ThePullingPlace.com

ThePullingPlace.com (https://www.thepullingplace.com/forum/index.php)
-   Rick Lance (https://www.thepullingplace.com/forum/forumdisplay.php?f=111)
-   -   Testers needed (https://www.thepullingplace.com/forum/showthread.php?t=708)

RickDLance 12-13-2008 05:59 PM

Testers needed
 
I'm needing a few testers for some minor changes I want to make in my header setup. If you're interested in getting a set of headers for a discount and don't mind getting your hands dirty then please PM me. Thanks!

ChevyDieselLLY 12-14-2008 05:19 PM

Rick i will be building an engine March - April time frame. it will have stage 2 heads from SoCal, full bottom end, dual fuelers, turbo is undecided but at the moment i am thinking about a GT42 or GT42Mag. Dustin and Winston at Diesel Addiction will be doing the build and will have a little more info on the specs of the engine. i know Dustin just installed a set of yours. let me know if what i will be doing is something you may want to try out. but like i said it wont be for a few months.

RickDLance 12-15-2008 10:32 AM

Keep me in the loop. ;)

JIT 12-15-2008 08:36 PM

Rick are you building them for 24v cummins? If so I am all ears... need a T3 flange.

josh

RickDLance 12-16-2008 10:03 PM

Sorry, but just the Dmax for now.

04BlackSmoker 12-16-2008 10:58 PM

What kind of set up do you perfer to put these on???

RickDLance 12-17-2008 09:07 AM

To qualify you MUST drive your truck daily, make at least 40 pounds of boost
at WOT, make at least 1600 degrees egt on a regular basis, and make approximately
600 HP or more. You must also be willing to install and remove the headers
multiple times if needed and ship them back to me as needed.

DocDyno 03-08-2009 06:34 PM

Herders
 
Rick,
Just saw this. We have a DMax LLY in one of our engine dyno test cells at the present time. If you would like some real data, temps, pressures, A-B comparos, etc. Let me know. We could run the data for you while we are working on some calibration and component development with this engine.

RickDLance 03-10-2009 07:24 PM

Where are you located? Is it a stock motor?

DocDyno 03-10-2009 07:46 PM

We are in northern Indiana. Yes it is a stock motor.


All times are GMT -4. The time now is 09:55 AM.

Powered by vBulletin® Copyright ©2000 - 2021, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.